When using a control set up for 4-20mA input does the control have protection for input break?
On the 4100/6100/8100 series controllers the 4-20mA input shuts off its output and displays "OPEN" o
Original N Series
How do I enable setpoint ramping on my N Series control?
Ramp Rate Option: The 6100, 6600, 8100, 8200, 8600, 4100, 4200 Series all include provisions for setHow to connect a 3-wire RTD to a 4-wire input?
The compensation leads on a RTD are used to measure and compensate for the lead resistance. (3) WireHow do I calibrate my 4100/6100/8100 (N Series) control?
Click here for the West 6100, 8100, 4100 (N Series)calibration procedureIt is impossible to change the Hardware Definition code.
You are likely in the read only mode instead of the configuration mode or the input jumpers are in tCommunication Requirements & Settings for N Series 4100, 6100, 8100 Series Controls.
4100, 6100 & 8100 Series Controls In order to communicate with West controllers you will need thWhy am I unable to select the input code that I want in the configuration mode?
The instrument will only make available for selection, those input codes that match the input type aI have lost my unlock code on my N Series control. How do I find out what it is?
The factory default setting for the controller's unlock code is 10 on the N Series Controls. This nuWhat is PID and where can I find additional information?
ISE PID Technical ReferenceMy controller/indicator sometimes loses its configuration, why is this?
West controls indicate the loss of configuration parameters by displaying all decimal points in the