How do I wire a 4 wire RTD to a 3 wire input on a control?
You can connect a 4 wire RTD to a 3 wire instrument. Just use 3 of the wires. Generally
West 2800/3800 Series
- Changing from thermocouple to RTD input on 2810 or 3810
You must do the following to switch from thermocouple to RTD on the 2810 / 3810 series: 1) Rglx25v Fri, 08/17/2018 - 17:29
- How do I adjust the maximum and minimum setpoint range on my 2800/3800 series controller?
Enter SETUP Mode: (Use caution in setting parameters in the setup mode. Some of the parametersglx25v Fri, 08/17/2018 - 17:29
How to connect a 3-wire RTD to a 4-wire input?
The compensation leads on a RTD are used to measure and compensate for the lead resistance. (3) Wire- Why are the valve motor drive (VMD) outputs limited to 120V AC operation?
If the valve motor is driven directly by the controller output relays, the controller outputs are liglx25v Fri, 08/17/2018 - 17:29
What is PID and where can I find additional information?
ISE PID Technical ReferenceHow can I use a 2 or 4-wire PT100 probe with a West controller designed for 3-wire probes?
Below is based on connecting to a West 8100, 4100 4400 control. The informa