How do I wire a 4 wire RTD to a 3 wire input on a control?
You can connect a 4 wire RTD to a 3 wire instrument. Just use 3 of the wires. Generally
West/ Partlow MLC Series
Communicating with the MLC9000+ versus the original MLC9000
Most of the Modbus addresses remain the same in the MLC9000+. (2) exceptions to this are: ContHow to connect a 3-wire RTD to a 4-wire input?
The compensation leads on a RTD are used to measure and compensate for the lead resistance. (3) WireMLC nonvolatile memory writing limitations.
The number of write cycles as with most nonvolatile memory is rated for 100,000 write cycles. Read cHow do I setup Commander to operate with a West/ Partlow MLC control system?
West/Partlow MLC The MLC multi-loop control system easily interfaces with Commander Software. TheWhat is PID and where can I find additional information?
ISE PID Technical ReferenceHow can I use a 2 or 4-wire PT100 probe with a West controller designed for 3-wire probes?
Below is based on connecting to a West 8100, 4100 4400 control. The informa