How to connect a 3-wire RTD to a 4-wire input?
The compensation leads on a RTD are used to measure and compensate for the lead resistance. (3) Wire
West 4100/6100/8100 Series
Description
West 4100, 6100 and 8100 Series Controllers
How do I calibrate my 4100/6100/8100 (N Series) control?
Click here for the West 6100, 8100, 4100 (N Series)calibration procedureIt is impossible to change the Hardware Definition code.
You are likely in the read only mode instead of the configuration mode or the input jumpers are in tCommunication Requirements & Settings for N Series 4100, 6100, 8100 Series Controls.
4100, 6100 & 8100 Series Controls In order to communicate with West controllers you will need thWhy am I unable to select the input code that I want in the configuration mode?
The instrument will only make available for selection, those input codes that match the input type aWhy does my display show [OPEN] instead of the Process Value?
This error message indicates that the signal from your sensor is absent. This may be caused by a fauWhy does my display show [HH] instead of the Process Value?
This error message indicates that the Process Variable is above the upper limit of the range. For exWhat is the difference between the Dual Setpoint and Remote Setpoint options?
Standard controllers operate with a single target setpoint which is entered from the front panel. MoWhy does my display show [LL] instead of the Process Value?
This error message indicates that the Process Variable is below the lower limit of the range. For exWhy are the valve motor drive (VMD) outputs limited to 120V AC operation?
If the valve motor is driven directly by the controller output relays, the controller outputs are li