How do I wire a 4 wire RTD to a 3 wire input on a control?
You can connect a 4 wire RTD to a 3 wire instrument. Just use 3 of the wires. Generally
Controllers
Description
Proccess and Temperature Controllers
- My P6100 series control does not have the same control response as my older N6100 control. How do I setup the P6100 to control the same as the older control?
The difference in control response is likely due to differences between the settings for tglx25v Fri, 08/17/2018 - 17:29
- My Plus controller/indicator has a invalid Unlock code, why is this?
This problem is almost certainly caused by electrical "noise", but it may enter the controller or inglx25v Fri, 08/17/2018 - 17:29
- Changing from thermocouple to RTD input on 2810 or 3810
You must do the following to switch from thermocouple to RTD on the 2810 / 3810 series: 1) Rglx25v Fri, 08/17/2018 - 17:29
- How do I adjust the maximum and minimum setpoint range on my 2800/3800 series controller?
Enter SETUP Mode: (Use caution in setting parameters in the setup mode. Some of the parametersglx25v Fri, 08/17/2018 - 17:29
How do I change the decimal position in PV and SP in west 6100+ controller? There is a parameter shown in manual for decimal position (dPoS) in configure mode but does not show in display.
The Decimal Position (dPoS) parameter is only available for linear ranges such as 4-20mA. It iCommunicating with the MLC9000+ versus the original MLC9000
Most of the Modbus addresses remain the same in the MLC9000+. (2) exceptions to this are: ContI cannot activate Self Tune. What is likely causing this?
Self Tune cannot be activate if the primary or the secondary proportioning band is set to 0.I cannot turn on Pre-Tune. What is likely causing this?
Pre-tune cannot be activated if: 1) The setpoint is ramping.2) The process variable is less than 5%How do I calibrate my 4100+/6100+/8100+ (P Series) Control?
6100+, 8100+, 4100+ Calibration Instructions