ISE, Inc. .
|  ISEinc.com  |  Variac.com  |   Literature & Documentation  |

Frequently Asked Questions
 

 
Knowledgebase Home | Glossary | Favorites | Contact Knowledgebase Home | Glossary | Favorites | Contact
Search the Knowledgebase Browse by Category

[Advanced Search]

Advanced Search
* Query:
  Categories:
  Rated:
Search Results for "couple"
There were 10 questions found for your query:
  1. questionHow do I adjust the maximum and minimum setpoint range on my 2800/3800 series controller?
    Enter SETUP Mode: (Use caution in setting parameters in the setup mode.  Some of the parameters in this section can affect control response) 1) Power control.   2) Press and hold b ...

  2. questionDo I need to use terminal blocks that are made of the same alloys as the thermocouples?
    The introduction of an additional alloy such as a terminal or terminal block will not introduce an error as long as the two conductors are at the same temperature. Any errors caused by the addi ...

  3. questionHow far can I run my thermocouples?
    Very long thermocouple runs are possible as long as certain precautions are followed. Most instrumentation today have a high input impedance and thermocouple wire is relatively low resistance. ...

  4. questionWhat are the color codes for thermocouples?
    Thermocouple Color Codes: Thermocouple wiring is color coded by thermocouple types. Different countries utilize different color coding. Jacket coloring is sometimes a colored stripe instead o ...

  5. questionWhere can I find additional information covering thermocouples
    ISE Thermocouple Technical Reference

  6. questionWhat is the output of a thermocouple?
    Thermocouple output is a small voltage (mV) that relates to the temperature difference between the sensing end and the termination end. For the voltage relationship: Thermocouple Reference ...

  7. questionWhat are the different wiring configurations for RTD sensors?
    Typical Wiring and Color Code Configurations for 2, 3 & 4 wire RTD's

  8. questionHow to connect a 3-wire RTD to a 4-wire input?
    The compensation leads on a RTD are used to measure and compensate for the lead resistance. (3) Wire RTD (most common) sensing circuits measure the resistance in one leg and assumes the resistanc ...

  9. questionHow do I wire a 4 wire RTD to a 3 wire input on a control?
    You can connect a 4 wire RTD to a 3 wire instrument.  Just use 3 of the wires.  Generally a (4) wire RTD will have 2 white wires and 2 red wires.  The active element is between a ...

  10. questionCan I Use Type K thermocouple wires (extension) for an E type thermocouple? What aspects need to be considered for this different type of the thermocouple vs extension wire connection?
     You should always use thermocouple wire or thermocouple extension wire that matches the type of thermocouple that you are using (in your case E).  Thermocouple or thermocouple extensi ...

 

Ask ISE a Question

   

Headquarters
10100 Royalton Rd.,  Cleveland, OH  44133  USA
Phone: (440) 237-3200  Fax: (440) 237-1744
Email ISE Cleveland
 
Toledo Area Office
417 Tomahawk Drive,  Maumee, Oh 43537
Phone: 419-893-3330 - FAX: 419-893-2151
Email ISE Toledo  
 

ISE, Inc. Privacy Policy

Click for Cleveland, Ohio Forecast Copyright © 2005 ISE, Inc.  All rights reserved.


Powered by ActiveKB Knowledgebase Software