ISE, Inc. .
|  ISEinc.com  |  Variac.com  |   Literature & Documentation  |

Frequently Asked Questions
 

 
Knowledgebase Home | Glossary | Favorites | Contact Knowledgebase Home | Glossary | Favorites | Contact
Search the Knowledgebase Browse by Category

[Advanced Search]
Changing from thermocouple to RTD input on 2810 or 3810
Would you like to...
Print this pagePrint this page
Email this pageEmail this page
Post a commentPost a comment
Subscribe me
Add to favoritesAdd to favorites
You must do the following to switch from thermocouple to RTD on the 2810 / 3810 series:
 
1) Remove the compensator from terminals 1 & 2 (on housing)
2) Change S1 input switch form thermocouple position to RTD position.
3) Set Switches S2/1 through S2/6 as per manual.
4) Enter the configuration mode and set to the appropriate range code.

Installation/operation manual is required to make this change:
http://instrumentation-central.com/pages/obsolete_controller_models.htm
Visitor Comments
No visitor comments posted. Post a comment
Related Questions
Attachments
No attachments were found.

 

Ask ISE a Question

   

Headquarters
10100 Royalton Rd.,  Cleveland, OH  44133  USA
Phone: (440) 237-3200  Fax: (440) 237-1744
Email ISE Cleveland
 
Toledo Area Office
417 Tomahawk Drive,  Maumee, Oh 43537
Phone: 419-893-3330 - FAX: 419-893-2151
Email ISE Toledo  
 

ISE, Inc. Privacy Policy

Click for Cleveland, Ohio Forecast Copyright © 2005 ISE, Inc.  All rights reserved.


Powered by ActiveKB Knowledgebase Software